Tips on Using Redscale Films: Vary That ISO
3 45 Share TweetRedscale is the most simple experiment a lomographer can undertake (before you hit the dishwasher). But what does extended range mean and how can you use it?
Redscale film is simply normal negative film that has been loaded into the cartridge the wrong way around. This means you are shooting through the substrate the light sensitve coating has been adhered to. This creates a filter effect, filtering out the bands of light (some colours) leaving a red tone. By shooting the redscale film at the ISO it was rated for you are in effect underexposing it. This creates some quite dark, blood red images.
To expose it correctly and even more you can change the ISO on your camera. Lomography has created a very convenient, ready redscaled film called: Lomography Redscale XR 50-200. If you haven’t tried it yet, you should. This is guaranteed to work at any ISO between 50 to 200.
So what does varying your ISO do? Simply if you shoot at 50 ISO more light will be let through than if you shoot at 200. More light means less other colour is filtered out.
Shoot at 50 and you’ll get nice antique looking colour:
Shoot at 100 for orangy looks:
Shoot at 200 for deeper reds and oranges:
A word of warning, redscaling is a big experiment, and the type of light seems to change the result as much as the ISO so you never seem to be guaranteed a result, though what I can promise you when you redscale is unforgettable results.
Load up the Lomography Redscale 100 35mm film and achieve the warm-tinged effect produced only by exposing the negative on the reverse side! You’ll get breathtaking square shots evoking intensely warm, honey hues. See our selection of Lomography films here.
écrit par adam_g2000 le 2012-02-27 dans #équipement #tutoriels #film #redscale #film-speed #tipster #asa #iso #quickie-tipster #extended-range
3 commentaires